Lynx Distributor LED power supply cable - V01001000000
Victron's Lynx Distributor does not include a power supply for the Printed Circuit Board (PCB) inside the distributor. This PCB is essential for lighting up the LED fuse indicators.
The LED indicators will only work if a Lynx Shunt or Lynx BMS is included in the system, which is often too expensive for smaller 12V systems. With this inexpensive power cable solution, you can easily power a standalone Lynx Distributor and use it as it was intended.
Terms and Conditions
Free shipping for most EU-countries!
Datasheet download - V01001000000
Installation
VVVVEngineering's power cable comes with two M8 lugs to be installed
directly inside the Lynx Distributor. Thanks to the RJ10 connector, the
solution is plug-and-play. The lead with the 500 mA fuse must be
connected to the positive rail, the other lead goes to the negative
rail. If all positions are occupied, the power cable can be connected on
an occupied connection, making sure to connect the higher power device
first (closest to the busbar). The RJ10 connector can be connected on
either side of the PCB. Make sure to push it all the way in the
connector to ensure a good connection.
Technical details
System voltage: 12V (AGM, GEL, LFP, ...)
Output Current: Maximum continuous 100mA @ 40°C (This corresponds to the power consumption of a single Lynx Distributor, do not use multiple power supply cables or lynx distributors in parallel, the power supply will overheat)
Remark: The cables are glued to the PCB for mechanical strength only, this product is not water resistant.
Currently 3 items in stock
How it works
This brief video demonstrates the use of this Lynx Distributor power cable ref. V01001000000.